MercuryMac

I'm going to vote with Snopro on this topic. We have an old car forum here and we can stray a wee bit from that but politics and...

I'm not the type of guy that puts a SBC in every hotrod, so here's what I've been doing this past week. The bad motor that came in my...

I've had two different things that showed the same symptoms as you have. One; a bad coil will heat up and cut power badly, and then...

Welcome to Undeadsleds, from northern Alberta. I will be following your progress excitedly, because I have a '29 Model A in my line-up...

I can add to the spam; I have a place in my tool chest for my homemade stuff. There are quite a few bent wrenches and I use them once in...

The picture is of the afore mentioned bent wrench holding a bolt head and working. I have the pedal assembly bolted in there and most of...

Don't lend me your wrenches! pic one, is how I bent a brand new wrench, [a cheap one, Power Fist], to fit bolt heads inside the boxed in...

You're doing fine, carry on.

Bama, I have been using Ultra Flat Camouflage Dark brown hide the rough stuff. I've now got the little actuating arm made and fine tuned...

Welcome to the RRR site, from northern Alberta. I'm looking forward to seeing your 'build thread' on here.

Welcome back, ZZ.

I've always liked late fifties Mopars. Drive it like it is. My outlook is; fix a vehicle up to whatever goal you have, don't fix it down.

I agree, Bob. Today, I finished up the bushings in the pedals and mounting pedestal, but slowed down on building an arm to drive the...

There's at least one narrowing of an axle in my future, so I watched with interest. Thank you.

I like building new things but there's almost as much engineering that goes into making things look like they are only a few months old...