I wanted to make sure the pics would work, everything is different with this lap top. I bought this car as seen in the first pic. Who ever built it didn't have a clue. It had a 430 buick motor and a 375 trans, sold them. Air bags in the rear, the welds looked like a 10 yr old done them. Everything was cut with a torch. I stripped it down and cut all the chassis out but saved the front horns. The chop was terrible, I think I got most of it straightened out. The windshield frame was welded, siliconed and you name it. Bought a new alum frame. I built the chassis and then done most of the body work with the body off. I then set the body, shell, on and started building the floor frame work, aligning the doors as I went. The 9 inch was to wide and set 3 inches off to one side. I narrowed it 4 in on 1 side and centered the pinion, installed a pos unit and 3.25 gears with new 31 spline axles. Disc are going all the way around. I had a friend build a 350 turbo, Coan parts and deep pan. I have a 030 over 427 BBC going together, 425 HP steel heads, 650 lift hyd roller, H beam rods, JE pistons, steel crank. Dummie block is in it with the intake and carbs I'm running. Also have a champion alum rad, the fuel cell and battery sets in the rear in a rack that unbolts and comes out so I can remove the body. Got more done, just need to get more pics.