Thread: Homemada Tools
View Single Post
  #7  
Old 03-19-2015, 10:53 PM
MercuryMac's Avatar
MercuryMac MercuryMac is offline
Builder Junky!
 
Join Date: Jan 2013
Location: Northern Alberta, Canada.
Posts: 2,348
Default

I was using my old thread die holder the other day and wanted to show it to you. When you're making U-bolts you can't get a conventional die handle to turn past the other leg of the U-bolt so you need an extension so I made a pipe holder. There's an old half inch drive socket welded in one end and a piece of square tubing welded in the depth of the die in the other end. I bored a hole in the side of the pipe near the bottom, tapped it and threaded a sharpened bolt into it that will go right into the little countersunk hole in the side of the die.
Anyhow, I have two different sizes of these gizmos as I have two different sizes of dies in my set.
Attached Images
File Type: jpg IMG_1437.jpg (93.1 KB, 94 views)
Reply With Quote