View Single Post
Old 07-13-2017, 08:40 AM
Odies dad Odies dad is offline
Join Date: Sep 2016
Posts: 84

Got 'er done yesterday. Worked out pretty good. Had to borrow my dad's acetylene tank because mine ran out after the first bend. We wrapped some wet towels around the king pins and heated the closest part until it would bend with a piece of square tubing, then we did the same to the other side. Went back to the other side again and heated by the tie rod end side and used a drift punch to get it back to level, then the same to the other side. We decided that we had to go a little higher, so we did it again.I cooled things off with my knuckles and got the tie rod put back on. Turned out perfect.
Got the hubs, rotors, and calipers installed.
Reply With Quote