View Single Post
  #141  
Old 06-20-2019, 08:20 PM
sgtpontiac's Avatar
sgtpontiac sgtpontiac is offline
Older, Wiser and Still Buildin'
 
Join Date: Dec 2010
Location: S.E. Michigan
Posts: 7,016
Default

Quote:
Originally Posted by BillM View Post
So I found a few minutes today to put the motor roughly in it's place. I think it's going to be a decent fit, a few challenges but so far so good. I may have some difficulty getting the motor low enough to get the driveshaft to clear the underside of the rear cab mount/crossmember. I can only go so low with the motor, due to the oil pan/MII crossmember clearance, and I want the motor forward enough to clear the firewall. I also need to be sure of the clearance between the rack and pinion/harmonic balancer, so I was lucky enough to be able to borrow the rack back again for a few days. Hopefully I'll be solving these issues over the next few days without too much rework of anything! I guess a two piece driveshaft would be one way of resolving it.
LIKE A GLOVE!!! Nice...
__________________
My 96 GMC Rat Buildbuildthread
Reply With Quote