1957 Gerstenslager High School Shop Build

Rat Rods Rule

Help Support Rat Rods Rule:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
got the IRS trimmed to fit the boxed rails
going to set the pinion angle then weld
van rear axle.jpg

van rear axle 1.jpg

van rear axle 2.jpg
 
van CV.jpg

van cv 2.jpg

did a visual for the front frame mods
we will make better patterns after we figure out the direction we plan to take
we raised the CV up into the frame about 4 inches
this keeps our camber correct at ride height
 
I thought about that same setup for my car. It's wider than a same year Ford, so it would probably fit pretty good. Still might do it one of these days.
 
The crown Vic is easy
It is a bit wide for a lot of applications
But it’s working out good for this van

The rear is easy too, just a little more fab
 

Latest posts

Back
Top