Annoying Eric
Active member
- Joined
- Nov 27, 2012
- Messages
- 32
Engine is a 388ci with a high tunnel ram intake with twin 450 cfm carbs. It had horrible backfires, would stall all the time.
I rebuild the carbs end of last summer, installed power valve protection, new power valves and all that jazz. Car runs much much better but i still have a huge flat spot if i just completely put the pedal right to the floor quickly.
Im sure i can go down a bit in jet sizes and might help it. i know tunnel rams are a bitch on the street but does anyone know if a progressive linkage would help much??
Any ideas are welcome. I know alot of you guys have had your fingers in this stuff alot longer then i have so please enlighten me.
I rebuild the carbs end of last summer, installed power valve protection, new power valves and all that jazz. Car runs much much better but i still have a huge flat spot if i just completely put the pedal right to the floor quickly.
Im sure i can go down a bit in jet sizes and might help it. i know tunnel rams are a bitch on the street but does anyone know if a progressive linkage would help much??
Any ideas are welcome. I know alot of you guys have had your fingers in this stuff alot longer then i have so please enlighten me.