Second Wind - a Packard Gasser

[zzrodder]

Finished up the floor, removeable tunnel worked out OK.

[bob w]

Nice!

[zzrodder]

Finally a righteous vehicle to put my vintage Moon go pedal into! Needed a small notch in the tranny cover but looks right at home....
Made mounting pedestals for the Pro Car buckets from Jegs, kind of a knock off of early Mustang but I think they fit the period look, just need to weld nut plates to the floor.

[forbigpicture]

PUUURFECT!!!!

[Old Iron]

^^X2 on the puuurfect^^
The moon pedal is

[bob w]

You know just what to do. Every time.

[zzrodder]

Got the seats mounted, welded nuts to 2x2 1/8" pieces of plate and welded them to the floor, also 4 more for seat belts.
Mounted the TCI shifter, wanted one that didn't look too modern and billety - I saw Dr Crankenstein use one on the 37 Chev build, thought it would do nicely. Not feeling the Tupperware cover though, made my own from 18ga. steel, made it to fit the floor better too.

[soltz]

Very very nice
Next ????

[zzrodder]

More hacking on the headers - added a short turn to the collectors and electric cutouts, welded the old flange to the side to divert to 3" pipes. These electric cutouts are always smaller than the pipe size, so the 3 1/2" ones would have only been a little over 3" inside - solved that by upsizing to 4" cutouts

[Tripper]

Really lookin' good! Love the seats!

BoB