gold03
He lives in an "Altered State"!
I saw this on Lazze metal shaping, and thought I would make some. 18 g sheet metal 1" by 1 1/2" then drill two 1/8 holes evenly spaced. I cut all the sheet metal pieces then clamped and drilled them all at the same time. All of the holes are the same distance apart. I can use the Clecos to fasten a butt joint by placing the strip across the butt joint and drilling two 1/8 holes, then fasten with Cleco. The advantage is I can do it all from one side and not have to reach under or have someone help clamp it.
Clecos are only .99 cents each.
The hole is easy to weld with a MIG and a piece of copper backing after all the seam is welded. Gap in sheet metal can be adjusted when drilling the holes to allow for penetration if needed.
Clecos are only .99 cents each.
The hole is easy to weld with a MIG and a piece of copper backing after all the seam is welded. Gap in sheet metal can be adjusted when drilling the holes to allow for penetration if needed.