Reversed Corvair steering box

[dmw56]

Reversed the corvair steering box I bought at the last swap meet. These are nice light compact boxes. But for a traditional steering the the input shaft needs to be reversed.

[dmw56]

I didn't take pictures but you just disassemble the box. Drill a hole a little larger than the shaft in the screw in plug. Install the seal from the inside. Than plug the original hole.
Then reassemble the box.

[dmw56]

Should work good on a Model A, T or other small vehicle.

[Tripper]

Kool!

[bob w]

Done a few myself.

[Old Iron]

I've never done one, just read about it.

[dmw56]

This is the first time I've done it. I've owned one and watched YouTube videos.
It was super simple and all the parts to rebuild a box are available. The only hard part is finding a Corvair box!

[bob w]

Where did you source the core plug and seal? I have an iron Corvair box to do. Been years since I sis one.

[dmw56]

Originally Posted by bob w

Where did you source the core plug and seal? I have an iron Corvair box to do. Been years since I sis one.

https://shopcaliforniacustomroadster...-rebuild-parts

https://californiacorvairparts.com/1...ng-boxes-parts

[bob w]

Thanks for the contact.