seat position

I need some advice on handling seat position. I have a 33 chev master and the seats I have acquired are a pair of seats from a Hyundai accent. Mainly because they would bolt directly to the flat floor. When I place the seats in a comfortable position for driving I notice that it really hampers getting into the back seat area of the car.

Should I just go with a parallel seat position and not worry about getting into the back. I don't think I'd have anyone back there anyway. Or should I consider mounting the passenger seat slightly more forward so that it could be slid further forward?
Or is there another way of tilting the seat forward to get into the rear?

J

Did they came out of a 4 door car?
If so, you need to find some out of a 2 door so they will fold forward allowing access to the back seat.

Yeah, they where out of a 2 door. I suppose I could go the "my time isn't worth anything" route and find a way to extend the passenger track.

Unless you plan on driving from the back i wouldn't worry about it. How often do you need to use it [S

I had a 34 Chev 2dr. and the original bucket style seats were hinged at the front mounts so they tilted forward for rear seat access.

Thanks guys, I think I'll just not worry about it. Anyone getting into the back will be smaller and more nimble than I am.