distributor hang up, HELP!!

Rat Rods Rule

Help Support Rat Rods Rule:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I'm a little late with this, seeing as how you have the truck running again,but it sounds like you are installing the pump drive shaft upside down. There's a star washer in a groove that should go up against the block when you put the pump in place. This stops the shaft form sticking in the dist. and pulling out of the pump, with the result you have already seen.
 
pope, thanks for the info, it would seem that in my case with the ARP rod the snap washer would go at the bottom, but it is clearly marked UP, with an arrow. prehaps the stock pump shaft should have had this ring installed, but it certainly did not. anyway, as i said thanks for the info, the truck is running great now!
 

Latest posts

Back
Top