Rat Rods Rule / Undead Sleds - Hot Rods, Rat Rods, Beaters & Bikes... since 2007!

Go Back   Rat Rods Rule / Undead Sleds - Hot Rods, Rat Rods, Beaters & Bikes... since 2007! > Engine Q&A!

Engine Q&A! The spot for engine talk, Q&A & tall tales!

Reply
 
Thread Tools Display Modes
  #1  
Old 02-13-2017, 01:40 PM
Ken47int Ken47int is offline
Member
 
Join Date: May 2016
Posts: 52
Default Double hump heads

Anyone have any idea if the studs for the rockers are pressed in or are they threaded in? Thanks
Reply With Quote
  #2  
Old 02-13-2017, 05:28 PM
Old Iron's Avatar
Old Iron Old Iron is offline
Rusty Rat Rodder
 
Join Date: May 2011
Location: Willard Mo.
Posts: 9,378
Default

If they are factory then they are pressed in
Reply With Quote
  #3  
Old 02-13-2017, 09:10 PM
Ken47int Ken47int is offline
Member
 
Join Date: May 2016
Posts: 52
Default

Thanks old iron, I kinda figured that from the little bit I looked at them last night
Reply With Quote
  #4  
Old 02-15-2017, 01:12 AM
Torch's Avatar
Torch Torch is offline
Extremely dangerous with a torch!!!
 
Join Date: Jul 2008
Posts: 1,622
Default

you can install screw in studs if using high spring pressure with a radical cam
but a good trick was to pin the studs to the casting by drilling through the head and stud and installing roll pins.
__________________
Hessian
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 06:50 AM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Rat Rods Rule Inc.