Reptile dysfunction
Member
- Joined
- Jul 20, 2008
- Messages
- 22
With my 9" rearend (from a ford p/u unknown vintage) centered on the frame the input shaft yoke is offset to the right by about 3". Are all stock 9"s this way? And do I a)center the motor and trans and let the driveshaft run at an angle,b) set the motor and trans at an angle pointing at the yoke or find a different rearend because the option my friends suggest is having a shop cut down and reweld one side and then buy a custom axle. This would be out of the question due to cost. Some of you experienced guys please sound off. Thanks.
BTW. Above mentioned issue is on a 29 ford chassis boxed and z'd with a ladder bar setup.
BTW. Above mentioned issue is on a 29 ford chassis boxed and z'd with a ladder bar setup.