Berta

dutch · Mar 17, 2024

Looks plenty neat to me... plus there`s no show hemi in there either...

Just keep the barn closed and burn all four if anyone had any questions!

lowbudget50 · Mar 17, 2024

dutch said:
Looks plenty neat to me... plus there`s no show hemi in there either... Just keep the barn closed and burn all four if anyone had any questions!

Thanks buddy. I was hoping to hide it so you didn't see it. But I think that's a clean enough option. I'm going to buy the top engine cover for it also. So that will help hide some of the wiring on top of the engine and everything

dutch · Mar 17, 2024

I hear ya. It`s a big problem with any somewhat modern engine when trying to build a clean bay. Wires and their relatives always seem to be either too long or too short to get them cleaned up...

lowbudget50 · Mar 17, 2024

dutch said:
I hear ya. It`s a big problem with any somewhat modern engine when trying to build a clean bay. Wires and their relatives always seem to be either too long or too short to get them cleaned up...

Yeah I bit the bullet this morning and shortened up all the stuff that went into the cab for the pedal and the OBD2 port. I couldn't handle it

lowbudget50 · Mar 17, 2024

So close!!! Need to change coil pack connectors and run main power wires. Then attach all the grounds and it's ready to make smoke!!!! Not done but getting there. I was able to reuse the factory Ford keyed power and cranking power from the 2 prong plug that use to ,plug into the dura spark box to feed the computer!! It's the little victory's!!