Check Early Mustang they had two sizes the one is 32 spline with a 1 1/8 hole. There are a lot of aftermarket applications for the mustang box pitman arm. Count the spline on your box
Yes that trans was used by Tom Hager and a few other local guy. I was a good friend of Tom Hager may he RIP. But about being his design and used by Mark Marten I would have a lot of questions on that.
That trans was a hot item for a lot of local dirt track cars. We used that same trans in our...
I had one back in the late 70s. My uncle bought it new and before I got it he replace the 390 with a 428 CJ motor. It was a real fun car to drive.
It was black with blue interior
It been awhile since i been around. two yaers ago I bought a new house with three garages that were not more then shells. Spent the two years turning them into my shops. Well last weekend i finish got my baby in her new home. now I can finish her.
The 351 W take a 28 oz. Flex plate. There are two sizes and it depends if you have a large bell or small bell on the trans. the large is a 164 tooth plate and the small is a 157 tooth plate.
Also with the torque converter there is and early and late version. the early is from 1965 -69 and...
Was working at the fire department that day. Myself and one other fire fighter were up on the roof adjusting the dish when the chief came over the radio saying the the world trade tower just got hit be a plane. We both thought he was joking.
We can down and seen everyone watching the tv. Just...
The rear is a Dana 44 and should have a gear ratio of 3.92. I been awhile since I had one apart but if memory serves me right I think the axle is a 10 or 11 spline. the bolt pattern is 5 on 5 1/2.