Recent content by Strange willy

Hey billy if you aren't doing anything tomorrow there is a small show in Eustis, Ne about 50 miles SE of NP. Also you need to get your ride up here before the 3rd weekend of July there is a 3 day event they call Kearney Cruise nite, shows on thurs, fri nite and Saturday and lots of cruising...

I'm at 167" on my 31 Willys!

31chevrod hey cool truck got any other pics? Ya mike click the link under the pict that says AB-ie the 31 Willys build!

Hey 31chevrod check out my build we are kinda on the same path, 31" bodies, caddy motors, and Jag IRS. Mines kinda on the outside of the box build but I like where you are going with yours, if you would have found an 86 or older Jag they are more streamlined and cleaner to install. Good luck...

Use the blue 3m striping tape it is more plastic and makes corners easier!

Hey jml I believe it would work better on my caddy 500, they can be a little tricky to setup it needs a idle circuit kit to run better on a street motor. Setup right on a built motor throttle response is excellent. Let me know if you would like to sell yours. Jarrod

If the creases around the edge of the dent aren't sharp I have used air pressure to push them back out. Just watch how much pressure you actually use!

Welcome Chad. What part of Nebraska are you in? I'm in Kearney!

Sox and Martin This is owned by a shop here in town!

Welcome from middle Nebraska! Picts Picts Picts

Nice find![cl

Welcome from Nebraska!

Sawzall I found a few more Picts for you, the builders name is Pat McNeal you can google him and find a bunch of info on it!

Hey sawzall from what I have read and seen of it it's a 702 GMC truck motor hooked to a TH425 which puts the driveshaft on the pass side, it feeds a custom offset winters quick change. The motor is mounted backwards so the rear end would use reverse cut gears.