Search results

What is a good donor to get a throttle cable about 24 inches and a pedal from? Any thoughts? I need to connect it to a Rochester 2 barrel.

I'm lookin for a complete bag kit for my 60 Belair. Any thoughts?

But does it matter which wire goes where on the gauge as they're not marked?

Here's a pic of the fuel gauge I plan on using and my question is,,,,,,does on wire go to a positive connection and the other go to the sending unit? If it does how do I know which is which on the gauge cause I don't want to connect the thing and have 12 volts going to the gas tank and a...

I got the old master cylinder off and found out he had the small res going to the front and large going to the rear. But,,,,,the master cylinder is off a 1997 Chevy Silverado 2500, 3500 with power brakes and looks to have a large bore.

Hey,,,,Old Iron. Are you running a proportioning valve with it? And how are your brakes?

Would just like to get some ideas on master cylinders your running with now power disc on front and drum on rear.

Don't know the bore but found out the cylinder that's on it must be for drums front and rear cause the pro valve only has one in and one out for front and rear so I believe that's alot of my problem. Probably need something like a 70 Chevelle with disc. Your opinion?

Talked to a few of my friends and they think I should be able to get good brakes without a booster on my truck. I just looked at it again and noticed it was originally plumbed like this,,,,,,,,,,outlet on front of master cyl goes to the rear of the proportioning valve with 1 outlet and rear of...

Under my 37 Chevy truck I don't have alot of room and I installed Chevy 11 inch disc brakes up front and drums in the rear. I tried running it last year with just want the master cylinder but got to really lay on em to stop. I want to go to power but need a booster and cylinder that's small. I'm...

I put a stock 650 cfm on my 360 big block and when setting it up back fired quite a bit and took out the power valve. I took it apart and has a number 9 stamped on it. Should I replace it with another 9? The engine is stock with lake style headers. I've heard you should run them and check the...

I know your saying 71-87 truck but will a full size van the same years work?

I sure would like to know what master cylinder n booster they're using. I could get one at the bone yard.

It would be nice to find spindles that bolt right up to my suspension.

On my 63 Chevy truck I have the old single well master cylinder and want to install a power brake dual well master cylinder. Does anyone know what is a direct bolt up to mine?

Are you saying I can use 71-87 spindles that would bolt right up to my arms? If so that's cool then I can run disc brakes. I'm trying to find out what power brake master cylinder will replace the single well one on it now. I see theysell them but they have to match up to something.

My new project was shipped Sunday and I can't wait to rip into it. Got a question though. I want to lower it as low as I can go without a c-notch. What are some of the suggestions you all have here. I don't want to heat the springs either. It's a 1963 Chevy C10 with the straight 6 cylinder, runs...

Very nice job on the pics Rodding, I like em. Too bad something rusty didn't win though,,,,lol

I can't move the box, no room with the big block. So uphill shouldn't be a problem? As far as the tire hitting the steering link, what about a bend in it like a z to have the clearance? Any danger?

My steering link goes uphill from the steering box because the shocks are in the way, Is there any way I could put it on the lower part of the axle? Also on a left turn the tire hits the steering link. I posted this cause alot of you have great ideas and that's what I need.