Search results

Also keep your eyes and ears open for the good deals and jump on them before there gone. Know what you want and try to get as close to it as possible or you won't be happy in the end or give up.

Just an ideal, but what about swapping out your old centers into newer wheels?

I think alot of it has to do with how much play most have in the rod that goes up and down. The part where your pipe fits in to pump your rubber piston up and down. On most they will have alot of slop causing the rod and piston at the bottom to go in all sorts of directions, till it develops a...

Me too just like he said above, the only difference is I take some electric conduit and grind one edge sharp and chuck it up in my drill and it make a nice clean hole with out it climbing up your drill bit.

It's been heavy duty work getting this big boy tore down down. Will post pics. when I get old frame out from under it. Have to build a cab lift to remove from frame.

If it is on the inside, drill small holes that connect on both sides and just split it in half.

Back problems are the worst, especially when you cant hardly even get up and down on the stool! Get well soon and take it easy till healed.

I have 5 in right now, but just bare frame still. Want enough room to still haul parts. Maybe it's a mid-westeren thing?

I being new here have wondered why alot of beds on trucks are made with not enough room to haul anything and with rear suspensions with huge travel? Since I'm just starting mine I want the best of both worlds, any ideas?

Here's what 46 20's look like.

This old 46 was bought new and kept till the man was in his 80's. He did a restoration on it and then became to old to drive it. I got it because it is 95% rust free and that makes a project so much easier. The motor only had water in it and that took it's toll here in indy during a winter...

before pics Here's some before pics.

Hello all, I have been into cars and truck now for 34 years and have never built an open wheeled car or truck, so I thought it was time. Starting with the truck in my avatar, using the cab and hood, 1/2 ton front axle,2 by 4 frame, and was wondering what sort of grille would fit my pointed...