pistolpete
Well-known member
So I've come into possession of a recently pulled and running 59A that I am going to see if I can get spinning. Is there anything specific I should do before I try and crank it over? Going to hook up an oil pressure and temp gauge before I try and start it, and need to make a down and dirty run stand as the frame isn't ready for it.
It turns nicely, I haven't checked compression cause everything I have read says it needs to be warm for a true reading. This is really the first flathead I have played with, so any advice would be greatly appreciated.
Thanks,
It turns nicely, I haven't checked compression cause everything I have read says it needs to be warm for a true reading. This is really the first flathead I have played with, so any advice would be greatly appreciated.
Thanks,