Recent content by 32chevymedic

Thank you zzroder that helps alot. I might try and bag the front to ghet the look. Although the shovel to dig the holes would probably be cheaper bluenorther thanks guys

where can i get info on moving the front end? do i need a new one or can i use stock? i like the look of the ibeam 4 inch drop axle but i have been told the front axle out of a 2 wheel drive jeep cherokee would be easiest to work with.

I will get some pics of it soon i still have the body on it right now

Thank you both. Very good points i do plan on moving the front end out. I may have to run bags to get the look i want when it is parked. Thank you again

I have a 1932 chevy sedan. My plan is to lower it down to about 1 inch of clearance. I figure i will have to c-cut the rear of the frame to get my ride height. My ? is should i cut the frame and leave the front stock ride height or what is the best way to go about it.[S

Pic

plans Thank you for the warm welcomes. My plan is to go back in with wood for the inside but using red cedar and clearing it to bring out the red. probably a 6 inch chop. Plan on dropping the whole thing about 16-18 inches. Any advice would be greatly appreciated. I will get pics on as...

New to the rat rod world but have always loved the look. I would rather have rust over shiny any day. I have picked up a 1932 chevy sedan that is going to get chopped [;) , lowered, and fast. i got the four door due to having a family of four and needing the room.