I got the color on! It is a little hard to tell what it is going to look like in the sun but so far I really like it. I don't know if it has dried enough to tell how flat it is going to end up.
Hopefully I'll put it togeather tomorow...
I forgot to mention I used POR15 under all my parts. I have had a gallon of this stuff for 5-6 years and its still good. I keep putting it in new cans becuse it gets sealed shut and I have to cut it open but the stuff is still good. This time it must have had a air leek becuse it had the top...
Speedway motors sells one for the flathead fords using your original clutch linkage thru the adapter. I don't think its all that bad on price. Im planning on buying one for my truck.
But I understand if you want to build your own. I try to do that as much as possible.
Well I got my bed, running boards, and rear fenders primed last night. I have to wait on the tailgate until I get the lettering to finish it off but hated seeing all this work sit and rust.
I say build what you like. Chevy's are much cheaper.
I have always been a GM guy but I like to keep it in the same family. A ford is a ford keep it that way. I lucked out and got a flathead 8, its just cool! Im not sure what I would have done if it was anything else. I guess to me its...
I think I am finally done welding for a while!
I finished up the tailgate with the brackets and chains. I also added some trailer strap eyes mounted flush to the bottom of the bed to strap things in. Like my chopper. I'll have to add some welds when I get the bed flipped, I have them just...
Thanks Mr. Clown! I'm happy with it so far. Getting a little burned out with it lately so I think it's time to paint the back half and drive it! That always helps me get motivated again.
I managed to get my tailgate welded up and mounted. All I need is the ford lettering and the bars to look like OEM.
Its a lot heavier than I thought it would turn out but thats ok.
Tomorow I hope to finish up the latch. I decided to cut out pieces to go inside and use the chain hook like...
Good morning guys!
I got a little further on the bed build the last couple days.
I made a set of taillight buckets, and frenched them into the roll pan.
I pulled the licence plate mount off my Cutlass until I finde one for the truck and mounted it. I want to add a hitch behind the licence...
Ive been busy but got a lot done. Some updated pictures...
Next step is to french in my 1950 Pontiac taillights and use a oldsmobile licence plate flip mount to finish off the roll pan. I want to put a hitch behind the licence.
Then the tailgate!
I got a little more done last night.
I finished up the front of the bed, framed it in with 1x1 tubing and sheeted it.
I mounted my new fenders.
I started the lower part of the bed sides extending them down to the bottom of the fender. I am going to build a roll pan so I trimed them off in...