squeaksworld
Active member
Im back!!!!! so I have been building a new rat its a 1939 chevy on a homemade frame with sbc 350 and auto I will post some pictures and then ask for input
39 chev truck
- Thread starter squeaksworld
- Start date
Help Support Rat Rods Rule:
squeaksworld
Active member
pics of frame start and cab
so here is my frame work. I am not a professional welder this was actually the first thing I used me welder on. my brother is a trade welder and said they were good for my first welds.
so here is my frame work. I am not a professional welder this was actually the first thing I used me welder on. my brother is a trade welder and said they were good for my first welds.
Attachments
-
303942_499832853361493_141127916_n.jpg -
420458_499833340028111_255260056_n.jpg -
1003216_662023427142434_1315040037_n.jpg -
1185503_662023533809090_1978028365_n.jpg -
1235106_662023653809078_755816325_n.jpg -
1175166_662726707072106_867439051_n.jpg -
1236963_662023283809115_610071389_n.jpg -
1237589_662023900475720_1462709988_n.jpg -
1238908_662023097142467_637434760_n.jpg -
1174545_662069913804452_597077443_n.jpg
squeaksworld
Active member
where i am at now
so I changed the rear of the frame cut it down not so drastic I have the engine set between the frame rails wondering about the material to use to build engine mounts and a cross-member for it. I have 1/4x4inch flat bar just wondering if it will be enough for the 350 and auto. also a shot of the donor car
so I changed the rear of the frame cut it down not so drastic I have the engine set between the frame rails wondering about the material to use to build engine mounts and a cross-member for it. I have 1/4x4inch flat bar just wondering if it will be enough for the 350 and auto. also a shot of the donor car
