1952B3b23
Well-known member
Hey Guys,
So ive been having problems making a decent looking fillet weld. Im using a Miller Millermatic 180 with .030 diameter wire and argon/CO2 mix shielding gas. The material that im welding is 1/8" thick mild steel. The welder settings are as follow:
Wire Speed: 65
Voltage: 4.5
Shielding Gas Flow: 25 CFH
The attached pic is of a bead i ran today on my truck frame. I ran that in the horizontal position even though in the pic its vertical. I have the frame on a homemade rotisserie so i was able to spin it. I havent always had this problem running fillet welds it just started recently and i cant seem to correct it. Any advice?
Thanks,
-Chris
So ive been having problems making a decent looking fillet weld. Im using a Miller Millermatic 180 with .030 diameter wire and argon/CO2 mix shielding gas. The material that im welding is 1/8" thick mild steel. The welder settings are as follow:
Wire Speed: 65
Voltage: 4.5
Shielding Gas Flow: 25 CFH
The attached pic is of a bead i ran today on my truck frame. I ran that in the horizontal position even though in the pic its vertical. I have the frame on a homemade rotisserie so i was able to spin it. I havent always had this problem running fillet welds it just started recently and i cant seem to correct it. Any advice?
Thanks,
-Chris