bruno
Crusty Rusty Old Rat Rodder!
I need to make a 2" block to put under my suicide perch to raise my front end, like wise I need to make 2 2" lowering blocks for the rear springs. I could put a 4" block in the front but I don't think that would be safe. Lowering the rear 4" isn't an option because it puts the oil pan to close to the pavement.
That's a lot of hot air for a simple question, would 3/16" tubing be ok (I have some) or should I use 1/4"? The ends will be boxed in.
As a side note would 1/16" hot rolled sheet steel be ok for the floor, I can get 36ga cold rolled but it is thinner and cost more $s.
Yes, I am back to piddling on the Dodge but nothing worth posting about.
Thanks, Randy
That's a lot of hot air for a simple question, would 3/16" tubing be ok (I have some) or should I use 1/4"? The ends will be boxed in.
As a side note would 1/16" hot rolled sheet steel be ok for the floor, I can get 36ga cold rolled but it is thinner and cost more $s.
Yes, I am back to piddling on the Dodge but nothing worth posting about.
Thanks, Randy
Last edited: