agdeuce
Well-known member
Here are some pics of my 36' Ford pickup project chassis etc. I started with a 38' rusted out chassis. The back half was gone. I used 2X4 rectangular tube and kicked the back 21" (I used a 9" from a 74" Torino with coil springs because I had it). I ran the tubing inside the old rusty rails and formed them to follow the frame forward to the "X" member front. I also kicked the front frame up 6" and lengthened it 6". Then a I shortened the "X" member and kicked it to match. Shortening the "X" member opened the gap between each rail allowing more room for trans and mount. I am using a 250 inline 6 with an S-10 5 speed trans. You use what you can find and afford even though it may mean a lot of work. I hope I got this picture thing right. Later