Flipper_1938

Anybody find a well made evaporator unit that will fit in the confines of a hot rod (that can be bought at pull-a-part)? I know rear...

Not this exactly, but it has the roll at the top of the dash and a big gauge panel under the roll.

The next time I go to dad's house, I'm going to see if the white speedometer housing can be flipped upside down. I had a revelation...

Yeah, I never considered having to drive the bolts out. I hope I can get them out from the outside. Even if I had a hole in the frame...

Bronco eww in blue!!!!

This is what I had in mind for gussets and access. Bolt center is 2 inches from top of link mount. Other bolt is 2 inches from bottom...

You think the bracket will fail? Or the nut will be hard to get to?

The inner channel will stay open to allow access from top and bottom.

I think I got the front frame mount mostly figured out. I was going to have it centered on the mounting plate, now I think it needs to...

Looks like frame mounts are gonna be fun. Outboard of frame rails and lower mount way below.

Can shows size of my 4 link tabs.

I now have two bases that will be shock mounts, sway bar mounts, bag mounts, and four link mounts.

I decided to go ahead and mig it. I figured out a bad insulator in my nozzle was what was causing my issue. With a new nozzle, I can...

The tire/wheel stance in the front fender looks great. I think there's a thumbs up mind thing going on there because of it. 10" ground...

On that big of a truck, having 1/2 the tire above the wheel covered by the fender will sure look low to the average Joe, and he is going...