Sorry Torchman, I was being a bit of a smart ass taking Bertram Russel's version of Occam's razor and adding it to a much used anecdote about dodging a trap in logic. No insult intended. Just having some fun. ;)
I would like to copy this chop
I may have posted this before but here goes any way. 10" chop/3" channel:
It is on youtube also:
http://www.youtube.com/watch?v=3WeCb7hqumA
Do you use these flat plate tables to build frames on? Or do you recommend a grid type table/jig built of rectangular tubing for the frames? Do you get the tables ground after assembly to assure flatness? I once had some work done by a builder that had a 6'x12' cast iron table with a grid of 1"...
Hey lowroder, I have been following your thread and you have a nice start going. I wish I had the money to buy it. Yours is in a lot better condition than mine. I had a wild assed idea to get a second body and build a teardrop type trailer out of it. The would look pretty crazy; 2 identically...