Ok, I bought a set of early front hydro backing plates. They are going out to powder coat tomorrow but I have a couple of questions.
1. On the backing plate, there are 2 springs on the rear that are attached. Are these removable? If so, where do I find replacements? I want to strip these down...
Question for you... I noticed you posted you were from Kitsap County. Where at? Im here in Bremerton. Would be nice to meet some locals...... im in the process of my build also
I have a 25 Maxwell cowl.... I built the frame. The cowl is just welded on with some holes that were drilled and then filled. Im now thinking about using rivets to attach the cowl and the side panels. Im not exactly the best welder when it comes to thin material
no pop rivets.
I was looking at a air tool that seems to hammer in the rivets. I watched the gun on a youtube video but I was wondering if you have to be able to access the back of the rivet for this tool.