Recent content by SinnerS hot rods

Here are a few more shots of the white sedan.. struggling with a name for it? I typically name the cars so that when customers call they can say i like "insert name" and i can quick reference in my head the amount of work and $$ it will take to make that happen.. Any suggestions?[S

Just busy i guess, i have a baby now 11 months and 1 on the way so i dont get a lot of time to sit in front of this computer. Our shop has more business than ever though so no worries about a shortage of our stuff coming out.. Everyone has been asking for awhile about a new frame design my cnc...

Hello Friends, We have been MIA for awhile from all forums but we are back here to give updates on things we are doing now and shots you all havent got the chance to see yet of some things we have done since we have been gone Check it out!

Few shots outside the front of the shop today.

well the allignment of that diagram went all over hydro cylinder to frame rail and bottom of hydro shaft to bat wing bat wing bolts in middle to axle and when cylinder goes up it pushes bat wing down which is attached to coil over top of coil over attached to bat wing and bottom attached to...

correct /|\ /O \ hydro coil over cylinder here on on left bottom \ here at bottom/ circle is wheel and | down is tabs for the batwing that will mount in center of axle hydro cylinder mounts to frame rail coil over mounts to lower 4 link bar and bat wing so...

Looks BAD ASS!

We are getting ready to do this setup..Im using Hydraulics to coil overs and my question is Does the coil overs have to be at the same angle as the hydraulic cylinder? I will be using a bat wing style setup with the pivot in the middle or something similar to a boom a rang with a center piece pivot

Updates the sedan is a full roller now

Cold Hard Steel Coupe released shot from the photo shoot

I wish it was my license plate holder it would be a dirty mess all the time

Thanks Neverdone, the shoot will not be released for a few months.. Rat rod magazine is picking it up for their mag and doesnt want any of the shoot released until the magazine hits the shelves..just a waiting game now.. i will keep ya updated though

photo shoot teaser

updates, headers and headlights and shell is on side glass and back are installed just waiting on front glass to finish being cut its all the way down to plumbing and wiring now then we will be on the road next weekend! Next updates you see should be it on the ground and out side

few updates with car back on ground and engine coming together