Recent content by ZippyDoDog

Gus, sorry, just had to dig up this "oldie" I notice on your eBay plans, it's for 2x4 tubing. I'd have to go way back on this thread to be sure, but wasn't this one 2x3? Just curious, are they basically revised plans from this build? BTY, this is probably my favorite build of all times. Love...

Where'd ya go?? :confused:

thanks I gotta tell ya; I've done a Camaro front clip on a 54 a couple years back, and now this but IMHO the Camaro clip was a hellava lot easier.

I ended up keeping the vibration dampener. It's kinda hard to tell from the pics but everything lines up nice and straight/true. It's just dry fitted for now. I'll probably take the shaft back out for the engine/trans installation. I bought a support bearing from Speedway which I'll install on...

Just in case someone reads this thread who is also looking for a coupler, I did find one at Summit: Flaming River Steering Coupler part # FR1945 both ends are 3/4" DD Of course, thanks to the help on this board, I don't need one now.

Forgot to mention in the beginning. Here's a Photoshop version of the look I want.... A local sign painter who has lettered two trucks for me says he can letter it and make the lettering look 50 years old.

Worked on a couple wheel tubs today. [;) I'm thinking I'm gonna order a shaft bearing, so something to do in the mean time.... They're not mounted yet, just a dry-run....

I'm kinda looking at that. With the new U-joint on the end of the new column, the dampener and the rag joint on the box.... that's three. Guess I better get me a bearing. Thanks for checking Joker, I like the looks of those. Thanks, wish me luck that it works out.

I'd like to keep it, but I'm thinking if I do I'll need a support bearing. And, I don't have any real good place for a bracket.

I'm thinking if I leave the vibration dampener, I'll need a support bearing. I would just go ahead and add one, but I don't have a real good place to bracket it.

Getting to work on the steering shaft. (thanks again to Jimmy Wallbanger, deerchooper & bob w for the suggestions) First, tear apart the s-10 column for the dd shaft and sleeve/connector.... and here's the dd sleeve that I wasn't able to find aftermarket.... Now I'm trying to decide whether...

Thanks again. I tore into the s-10 column and sure enough there's everything I need.... One more question. I wondering if I can leave the vibration dampener in also. It's not rigid but it's not as flexible as a U-joint either....

I had torn down an old deck/porch that I saved the weathered decking boards just for this project. The deck was sagging in the middle so the boards are warped, low in the middle but I think over time they should straighten up. They're not fastened yet because I need to take them back out to work...

Thanks guys. I do have a spare S-10 column. Any idea if it would have one. I hate to cut it up, I thought I may use it sometime in the future, but maybe I'll tear it apart if it has a sleeve.

That's s nice set up. I don't have a junk column laying around. There's no place you can buy the sleeves?