Started intalling my dual carb intake the other day. It was made by a guy named Moose who may be a member here but I know is on the HAMB. I had to widen out some of the bolt holes but otherwise I'm happy with how it came out.
In the process of installing the manifold I ended up making a block off plate for the old heat riser. I also did a little bit of cleaning and painting on the exhaust manifold.
Next is to figure out how I'm gonna run the linkage, and decide whether I'm gonna get fancy with a fuel block or just T it off and run some additional fuel line. I originally wanted to run the linkage towards the middle of the motor but may have to run it outside the carbs.
Here are some pics.
In the process of installing the manifold I ended up making a block off plate for the old heat riser. I also did a little bit of cleaning and painting on the exhaust manifold.
Next is to figure out how I'm gonna run the linkage, and decide whether I'm gonna get fancy with a fuel block or just T it off and run some additional fuel line. I originally wanted to run the linkage towards the middle of the motor but may have to run it outside the carbs.
Here are some pics.