Ratcrazy
Well-known member
I have a rearend out of a 80 model F150. After setting the engine in the frame and centering it between the rails I fabricated my engine mounts and got those tacked in place. I put the rearend in position and the yoke on the rearend is 2 inches to the left of center looking from the front. I dropped a plumb-bob in the center of the rails and took these pictures.
What kind of effect is this going to cause in the drivetrain?
How can I get the rearend yoke and the transmisson yoke to line up?
Should I relocate the engine out of center or look for another readend? If another rearend is needed what model Ford has a centered hogshead?
My thinking is if I relocate the engine and move it over out of center there goes the passenger side inside. No seat room
Thanks
Larry
What kind of effect is this going to cause in the drivetrain?
How can I get the rearend yoke and the transmisson yoke to line up?
Should I relocate the engine out of center or look for another readend? If another rearend is needed what model Ford has a centered hogshead?
My thinking is if I relocate the engine and move it over out of center there goes the passenger side inside. No seat room
Thanks
Larry