Ratcrazy
Well-known member
I have a rearend out of a 80 model F150. After setting the engine in the frame and centering it between the rails I fabricated my engine mounts and got those tacked in place. I put the rearend in position and the yoke on the rearend is 2 inches to the left of center looking from the front. I dropped a plumb-bob in the center of the rails and took these pictures.
What kind of effect is this going to cause in the drivetrain?
How can I get the rearend yoke and the transmisson yoke to line up?
Should I relocate the engine out of center or look for another readend? If another rearend is needed what model Ford has a centered hogshead?
My thinking is if I relocate the engine and move it over out of center there goes the passenger side inside. No seat room![Eek! :eek: :eek:](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
Thanks
Larry
What kind of effect is this going to cause in the drivetrain?
How can I get the rearend yoke and the transmisson yoke to line up?
Should I relocate the engine out of center or look for another readend? If another rearend is needed what model Ford has a centered hogshead?
My thinking is if I relocate the engine and move it over out of center there goes the passenger side inside. No seat room
Thanks
Larry