maddog
Here he comes to save the day!
My drive shaft is very short. From center of U joint to center of U joint is 14" or 15". Thats it.
It seems that my trans points slightly down, the pinion can point anywhere I want it to because I havnt made the brackets to hang it yet.
The thing is, it seems that the pinion will be slightly higher than the trans output shaft.
All the diagrams that I have looked at, showing proper pinion and drive shaft angles, show the trans output shaft higher than the pinion shaft.
What do you think about this?
I can keep the angles to just a few degrees, but will it work?
The trans output shaft is in the center of the vehicle but the pinion is off to the right side. Can I leave this offset?
Thanks
It seems that my trans points slightly down, the pinion can point anywhere I want it to because I havnt made the brackets to hang it yet.
The thing is, it seems that the pinion will be slightly higher than the trans output shaft.
All the diagrams that I have looked at, showing proper pinion and drive shaft angles, show the trans output shaft higher than the pinion shaft.
What do you think about this?
I can keep the angles to just a few degrees, but will it work?
The trans output shaft is in the center of the vehicle but the pinion is off to the right side. Can I leave this offset?
Thanks