oldmule
Active member
I have a rather rare bell housing that I need to fix two cracks in. My TIG is DC only (yeah I know) but have heard of people MIG welding AL. I have AR and AR/CO2 blend gases and a Millermatic 175 welder. Can it be done?
Just because some of you will ask, it's a braced case TH400. The cracks are 2" long on the top dome lip and dr side above the alignment pin hole. I think the tranny bolts came loose on it because the alignment holes are wallowed out some. This is for a crawler build that has to be done before I can start on my 18 Dodge.....
Just because some of you will ask, it's a braced case TH400. The cracks are 2" long on the top dome lip and dr side above the alignment pin hole. I think the tranny bolts came loose on it because the alignment holes are wallowed out some. This is for a crawler build that has to be done before I can start on my 18 Dodge.....