Bamamav
Well-known member
I think I may have screwed up when I set my pinion angle. I thought I had it right at 3* up, the tranny is 3* down, so it should balance out. I've got a pretty good vibration above 40-45 MPH, nothing below there. I'm thinking I may need to go back and check it again, going to have to run the car up on some boards level because it's so low I can't get under it.
If it's off, what would be my best bet on shimming the rear to get the proper angle, buy some of those wedge plates they sell just for that, or just make something work? [S
If it's off, what would be my best bet on shimming the rear to get the proper angle, buy some of those wedge plates they sell just for that, or just make something work? [S