maverickmk
Rebel Rodder
I have a friend that is wanting to shave the marker lights on his Cuda. There is a relief or indentation (?) where the marker fits into (see pic)
What is the best way to do this? He heard to "just mud it in." I told him that would be the worst way. I told him he needed to weld in a patch the same size as the hole - not knowing there was an indentation. He sends me the picture below. Overlap onto the indentation? Try & hammer out the indentation? Suggestions?
What is the best way to do this? He heard to "just mud it in." I told him that would be the worst way. I told him he needed to weld in a patch the same size as the hole - not knowing there was an indentation. He sends me the picture below. Overlap onto the indentation? Try & hammer out the indentation? Suggestions?