Nope! I'ts not gonna be an RPU. Just going for a certain look. Then I cut the windshield post and took 4" out. Next cut was below the windshield and cowl sides, but leaving attached on door post. Then I tilted to the angle I wanted and scribed and taped from from the lower cut line. Removed the frame and cutto scribe. Tacked it back into place. Also cut the back down 5 1/4", may end up going more. The rear window area and back of the cab is pretty beat up and has to be replaced. The roof has major dents and creases as well. May just end up rolling a new panel. You'll have to stay tuned to see! Ran out of time today. (this was Saturday, only day I could squeeze in)