Ok, here goes! Waiting to take delivery on my new Ron Pope Motorsports 23 T-Bucket body. It's unchannelled, but I want to lower it 3 inches. I'm thinking all I have to do is position it on the frame where I want it and mark out a couple 3 inch deep cuts in the firewall, and trial fit/cut the back end to get it to sit like I want it. Is that it? Sounds way to simple. Anybody got any suggestions on what not to do? What worked, what didn't work, what would you do different, etc, etc, etc!!!
And should I resin over where I cut it to reseal it?[S
And should I resin over where I cut it to reseal it?[S